Serial CAD/CAM Bracing: An Alternative to Serial Casting for Early Onset Scoliosis.

BACKGROUND

Years of casting for infantile scoliosis can lead to significantly detrimental quality of life for both the child and parents. Concerns have been raised about the long-term negative neurodevelopmental effects of repeated anesthesia on young children. We developed an elongation bending derotation brace (EBDB) that uses primarily a bending derotation force applied to the curve to achieve the same goals as the cast. The goal of the study is to describe the preliminary results of a technique for creation of EBDB for infantile idiopathic scoliosis using computer-aided design/computer-aided milling (CAD/CAM) technology with at least 24 months follow-up.

METHODS

Nine patients with infantile idiopathic scoliosis had minimum 2-year follow-up (mean, 3.4 y; range, 2 to 6 y). Mean age at the treatment was 11 months (4 to 24 mo). There were 2 right thoracic, 7 left thoracic curves. CAD/CAM technology was used to create the EBDB after the child was placed in traction and a derotation strap applied. The same rotational forces that are used in the creation of the Mehta-type cast can also be utilized in creating the brace. A laser scanner was used to obtain the spinal geometry. Compliance can be monitored with a heat sensor.

RESULTS

Four patients were full corrected with serial bracing alone (curve ≤10 degrees). Five patients with more rigid curves showed improvement from mean 57 degrees (48 to 62 degrees) to mean 21 degrees (10 to 44 degrees).

CONCLUSIONS

This paper describes the preliminary results of a new methodology for creating a patient-specific brace for infantile scoliosis using CAD/CAM technology. This methods shows promising potential to treat the infantile curve without the drawbacks of casting.

LEVEL OF EVIDENCE: Level IV.