Biomechanical Rationale for the Development of Atlantoaxial Instability and Basilar Invagination in Patients with Occipitalization of the Atlas: A Finite Element Analysis.

OBJECTIVE

Occipitalization of the atlas (OA) often is associated with atlantoaxial dislocation and basilar invagination. The purpose of this study is to determine the biomechanical difference between normal and OA conditions in the craniovertebral junction and to further explore the rationale for development of atlantoaxial dislocation and basilar invagination using the finite element model (FEM).

METHODS

A ligamentous, nonlinear, sliding-contact, 3-dimensional FEM of the occipitoatlantoaxial complex was generated. Validation of the model was accomplished by comparing kinematic predictions with experimental data. We defined the atlantooccipital joint as a tie contact to simulate the OA deformity. The range of motion and the value of the maximum Von Mises stress were compared between the intact and OA models.

RESULTS

We found all of the predicted data in the intact FEM fell within 1 standard deviation of the cadaver data for all 6 loadings. The OA simulation significantly reduced the overall range of motion of the occipitoatlantoaxial complex at all loadings. The maximum Von Mises stress was predicted to increase at the transverse ligament and the superior articular facet of the axis for all the flexion, extension, lateral bending, and axial rotation loadings.

CONCLUSIONS

The OA could result in hypermobility of the atlantoaxial segment and cause overstress in the transverse ligament and the lateral atlantoaxial joints. These changes explain the pathogenesis of atlantoaxial dislocation and basilar invagination associated with OA. Follow-up should be scheduled regularly due to the nature of the dynamic development of atlantoaxial dislocation and basilar invagination.