MedElevator Войти в исследования
← Поиск публикаций

DOI 10.3390/ma19101958

Медицинская библиотека · Materials (Basel, Switzerland) · 2026

Effect of Processing Parameters on the Creep Behavior and Integrity of Plasma-Sprayed Thermal Barrier Coatings on Ti-6Al-4V.

Rodrigues Bianca Costa, Takahashi Renata Jesuina, de Brito Vera Lúcia Othéro, Reis Danieli Aparecida Pereira

СтатьяПеревод в очереди

Аннотация

This study investigates how processing parameters and powder characteristics influence the mechanical performance of thermal barrier coatings (TBCs) applied to a Ti-6Al-4V alloy. Two TBCs were deposited by Atmospheric Plasma Spray (APS) using different processing conditions, feedstock characteristics, and coating thicknesses (thin and thick configurations). TBC characterization included powder size analysis, scanning electron microscopy (SEM), surface roughness, X-ray diffraction, instrumented indentation, and scratch testing. Mechanical behavior was assessed using creep testing at 125 MPa and 500 °C for coated and uncoated samples. Fracture surfaces of crept samples were analyzed by SEM and stereomicroscopy. Thicker TBC exhibited higher elastic modulus but contained microcracks and higher porosity, resulting in a higher steady-state creep rate (0.0006 h-1, approximately 167% above the uncoated substrate) and reduced rupture time. Conversely, thinner TBC remained initially crack-free, promoting stress redistribution and leading to a lower creep rate (0.0002 h-1, about 67% below the substrate) and delayed failure. Fractographic analysis revealed ductile fracture of Ti-6Al-4V in all conditions, indicating that coatings influenced damage accumulation rather than fracture mode. These findings underscore the combined effect of processing parameters and coating architecture on TBC performance for aerospace applications.

Для цитирования: Rodrigues Bianca Costa, Takahashi Renata Jesuina, de Brito Vera Lúcia Othéro, Reis Danieli Aparecida Pereira. Effect of Processing Parameters on the Creep Behavior and Integrity of Plasma-Sprayed Thermal Barrier Coatings on Ti-6Al-4V.. Materials (Basel, Switzerland). 2026. DOI: 10.3390/ma19101958.
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.