MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1016/j.ijpharm.2020.119580

Медицинская библиотека · International journal of pharmaceutics · 2020

Development and characterisation of novel poly (vinyl alcohol)/poly (vinyl pyrrolidone)-based hydrogel-forming microneedle arrays for enhanced and sustained transdermal delivery of methotrexate.

Tekko Ismaiel A, Chen Gaoyun, Domínguez-Robles Juan, Thakur Raghu Raj Singh, Hamdan Iman M N, Vora Lalitkumar, Larrañeta Eneko, McElnay James C, McCarthy Helen O, Rooney Madeleine, Donnelly Ryan F

СтатьяПеревод в очереди

Аннотация

Methotrexate (MTX) is one of the mainstays of treatment for rheumatoid arthritis (RA) and juvenile idiopathic arthritis (JIA) and it is mainly administered either orally or by subcutaneous (SC) injection, which are not so satisfactory. While orally administered MTX is associated with variable bioavailability and causes gastrointestinal side effects, including nausea and vomiting, SC injection is painful and produces high peak blood levels of MTX. Transdermal delivery presents an attractive alternative administration route. However, MTX passive permeation through the skin is hindered by the skin barrier and MTX physicochemical properties. To address these issues, hydrogel-forming microneedle arrays (HFMN) and a patch-like reservoir loaded with MTX (MTX-RV) were developed and combined to form a minimally invasive patch to deliver MTX transdermally in a sustained manner. HFMN were prepared from an aqueous blend of poly (vinyl alcohol) (PVA) and poly (vinyl pyrrolidone) (PVP) which was crosslinked chemically with citric acid (CA) at 130˚C. MTX-RV was prepared from hydroxypropyl methylcellulose (HPMC) and glycerol. Both the HFMN and MTX-RV were fully characterised and then combined to form an integrated patch, which was evaluated ex vivo and in preclinical studies. The HFMN demonstrated a satisfactory mechanical strength and insertion capability into excised neonatal porcine skin, as well as moderate swelling properties. The MTX-RV incorporated a high dose of MTX (150.3 ± 5.3 µg/mg) without precipitation. The integrated patch delivered MTX at a steady-state flux of 506.8 ± 136.9 µg.cm2/h in an ex vivo setup. Furthermore, in preclinical studies performed in Sprague Dawley rats, MTX appeared in blood after 1 h from patch application at a concentration of 7.6 ± 2.0 nM. MTX blood level increased gradually to reach its peak, Cmax = 35.1 ± 5.1 nM, at 24 h. Importantly, the HFMN were removed intact from the skin with only mild erythema, despite the cytotoxic nature of MTX. Accordingly, the integrated patch produced in this work represents a promising minimally invasive transdermal drug delivery system that can overcome the skin barrier and deliver MTX in a sustained manner. This may help in minimising or even avoiding the nausea and vomiting, associated with the conventional administration routes.

Для цитирования: Tekko Ismaiel A, Chen Gaoyun, Domínguez-Robles Juan, Thakur Raghu Raj Singh, Hamdan Iman M N, Vora Lalitkumar, Larrañeta Eneko, McElnay James C, McCarthy Helen O, Rooney Madeleine, Donnelly Ryan F. Development and characterisation of novel poly (vinyl alcohol)/poly (vinyl pyrrolidone)-based hydrogel-forming microneedle arrays for enhanced and sustained transdermal delivery of methotrexate.. International journal of pharmaceutics. 2020. DOI: 10.1016/j.ijpharm.2020.119580.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.