Global spine journal · 2017
Low-Density Pedicle Screw Constructs for Adolescent Idiopathic Scoliosis: Evaluation of Effectiveness and Cost.
СтатьяНазвание и аннотация: Перевод в очереди
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Tannous Oliver O, Banagan Kelly E, Belin Eric J, Jazini Ehsan, Weir Tristan B, Ludwig Steven C, Gelb Daniel E
Аннотация
STUDY DESIGN: Retrospective cohort study.
OBJECTIVE: To determine whether a low-density (LD) screw construct can achieve curve correction similar to a high-density (HD) construct in adolescent scoliosis.
METHODS: Patients treated operatively for idiopathic scoliosis between 2007 and 2011 were identified through a database review. A consistent LD screw construct was used. Radiographic assessment included percent correction of major and fractional lumbar curves, T5-T12 kyphosis, and angle of lowest instrumented vertebra (LIV). Costs were compared with HD constructs.
RESULTS: Thirty-five patients were included in the analysis. Ages ranged from 12 to 19 years (mean = 14.9 years). Average screw density was 1.2 screws per level (range = 1.07-1.5 screws). Mean percent curve correction at latest follow-up: major curve, 66.9%; fractional lumbar curve, 63%. Average postoperative thoracic kyphosis: 29.5°. Mean LIV angle: 5.6°. Average construct cost was $14 871 per case compared with $23 840 per case if all levels had been instrumented with 2 screws, amounting to an average savings of $9000.
CONCLUSIONS: Our LD screw construct is among the lowest density constructs reported and achieves curve correction comparable to HD constructs at substantially lower cost.
OBJECTIVE: To determine whether a low-density (LD) screw construct can achieve curve correction similar to a high-density (HD) construct in adolescent scoliosis.
METHODS: Patients treated operatively for idiopathic scoliosis between 2007 and 2011 were identified through a database review. A consistent LD screw construct was used. Radiographic assessment included percent correction of major and fractional lumbar curves, T5-T12 kyphosis, and angle of lowest instrumented vertebra (LIV). Costs were compared with HD constructs.
RESULTS: Thirty-five patients were included in the analysis. Ages ranged from 12 to 19 years (mean = 14.9 years). Average screw density was 1.2 screws per level (range = 1.07-1.5 screws). Mean percent curve correction at latest follow-up: major curve, 66.9%; fractional lumbar curve, 63%. Average postoperative thoracic kyphosis: 29.5°. Mean LIV angle: 5.6°. Average construct cost was $14 871 per case compared with $23 840 per case if all levels had been instrumented with 2 screws, amounting to an average savings of $9000.
CONCLUSIONS: Our LD screw construct is among the lowest density constructs reported and achieves curve correction comparable to HD constructs at substantially lower cost.