DOI 10.1007/s00256-022-04255-7
Routine chest CT combined with the osteoporosis self-assessment tool for Asians (OSTA): a screening tool for patients with osteoporosis.
Аннотация
INTRODUCTION
The osteoporosis self-assessment tool for Asians (OSTA) is a common screening tool for osteoporosis. The seventh thoracic CT (CT-T7) Hounsfield unit (HU) measured by chest CT correlates with osteoporosis. This study aimed to investigate the diagnostic value of OSTA alone, CT-T7 alone, or the combination of OSTA and CT-T7 in osteoporosis.
MATERIALS AND
METHODS
In this study, 1268 participants were grouped into 586 men and 682 women. We established multiple linear regression models by combining CT-T7 and OSTA. Receiver operating characteristic (ROC) curves were used to evaluate the ability to diagnose osteoporosis.
RESULTS
In the male group, the mean age was 59.02 years, and 108 patients (18.4%) had osteoporosis. In the female group, the mean age was 63.23 years, and 308 patients (45.2%) had osteoporosis. By ROC curve comparison, the CT-T7 (male, AUC = 0.789, 95% CI 0.745-0.832; female, AUC = 0.835, 95% CI 0.805-0.864) in the diagnosis of osteoporosis was greater than the OSTA (male, AUC = 0.673, 95% CI 0.620-0.726; female, AUC = 0.775, 95% CI 0.741-0.810) in both the male and female groups (p < 0.001). When OSTA was combined with CT, the equation of multiple linear regression (MLR) was obtained as follows: female = 3.020-0.028*OSTA-0.004*CT-T7. In the female group, it was found that the AUC of MLR (AUC = 0.853, 95% CI 0.825-0.880) in the diagnosis of osteoporosis was larger than that of CT-T7 (p < 0.01). When the MLR was 2.65, the sensitivity and specificity were 53.9% and 90%, respectively.
CONCLUSION
For a patient who has completed chest CT, CT-T7 (HU) combined with OSTA is recommended to identify the high-risk population of osteoporosis, and it has a higher diagnostic value than OSTA alone or CT-T7 alone, especially among females. For a female with MLR greater than 2.65, further DXA examination is needed.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.