Developing High-Performance and Low-Cost Paint Thermoelectric Materials for Low-Midtemperature Applications.

Most thermoelectric (TE) materials used to convert heat energy into electrical energy are expensive and, to a certain degree, toxic. Moreover, due to the chemical complexity in the synthesis process, some of the TE materials are not reproducible. Similarly, the scarcity of TE materials hampers their scalability. To address the above issues, this study presents an inexpensive, nontoxic, scalable, and highly reproducible paint-based TE module for the conversion of heat energy to electrical energy. Transport properties with structural analysis indicate that the electrical conductivity of the paint TE material is controlled by the concentration of graphite and sodium silicate, while the Seebeck coefficient is dominated by the ratio of n- and p-type Bi-Sb-Te. The results indicate that the as-developed TE module can withstand an operating temperature of up to 160 °C. At a temperature of 57 °C, the highest power factors of the as-synthesized n- and p-type TE paints are 1.34 and 1.42 μW/(cm K2), respectively. It is also found that the TE module can have a higher output voltage when the cold side of the TE module is allowed to float in the air in comparison to that when it is in contact with the human body. The performance of the paint-based TE module is measured on five parts of the body, namely, the chest, palm, leg, wrist, and neck; the wrist has the highest open-circuit voltage of 1.9 mV, indicating its suitability for wearable applications. Finally, at a temperature gradient of 30 °C, a maximum output power of 6.8 μW is attained.