MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1136/ard.58.9.582

Медицинская библиотека · Annals of the rheumatic diseases · 1999

Most calcium pyrophosphate crystals appear as non-birefringent.

Ivorra J, Rosas J, Pascual E

СтатьяПоддержка исследования: вне правительства СШАПеревод в очереди

Аннотация

OBJECTIVE

To determine the proportion of calcium pyrophosphate dihydrate (CPPD) crystals that appear as non-birefringent when observed under the polarised light microscope.

METHODS

Two observers examined independently 10 synovial fluid samples obtained during an episode of arthritis attributable to CPPD crystals. Ten synovial fluid samples from patients with acute gout were used as a reference. The examination was performed after placing a fluid sample in a Niebauer haemocytometric chamber; a crystal count was done first under ordinary light, then in the area corresponding to a 0.1 ml, under polarised light

RESULTS

The percentages of birefringence appreciated for CPPD were 18% (confidence intervals (CI) 12, 24) for observer 1, and 17% (CI 10, 24) for observer 2 (difference NS). The percentages of birefringence for monosodium urate were 127% (CI 103, 151) for observer 1 and 107% (CI 100, 114) for observer 2 (difference NS). Percentages above 100% indicate that crystals missed under ordinary light became apparent under polarised light.

CONCLUSION

Only about one fifth of all CPPD crystals identified by bright field microscopy show birefringence when the same synovial fluid sample is observed under polarised light. If a search for CPPD crystals is conducted under polarised light, the majority of the crystals will be missed. Ordinary light allows a better rate of CPPD crystal detection but observation under polarised light of crystals showing birefringence is required for definitive CPPD crystal identification.

Для цитирования: Ivorra J, Rosas J, Pascual E. Most calcium pyrophosphate crystals appear as non-birefringent.. Annals of the rheumatic diseases. 1999. DOI: 10.1136/ard.58.9.582.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.