Foot & ankle international · 2014
Influence of crosslinking on the wear performance of polyethylene within total ankle arthroplasty.
Сравнительное исследованиеСтатьяНазвание и аннотация: Перевод в очереди
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Bischoff Jeffrey E, Fryman J Craig, Parcell Jerry, Orozco Villaseñor Diego A
Аннотация
BACKGROUND: Wear debris of polyethylene within joint replacement systems can result in clinical complications including osteolysis and component loosening. Highly crosslinked polyethylene (HXPE) was introduced to improve these outcomes, and has been shown to result in improved wear performance in several joint replacement systems. However, bearing couples within total ankle replacement (TAR) systems have historically used conventional polyethylene (CPE) articulating on metal. The extent to which HXPE would result in a reduction of polyethylene wear compared to CPE in the ankle has not been studied. The hypothesis motivating this study was that use of HXPE within TAR will result in significantly lower wear rate than CPE.
METHODS: HXPE and CPE inserts within a semiconstrained, bicondylar TAR system were manufactured for this study. Samples were subjected to 5.0 million cycles of wear on an in vitro wear simulator. Testing was performed within a physiological environment, using kinematic and kinetic loading profiles characteristic of walking gait. Samples were weighed at regular intervals to determine gravimetric mass loss, and the morphology of wear particles was analyzed.
RESULTS: The wear rates for CPE and HXPE samples were 7.4 ± 1.3 and 1.9 ± 0.3 mg/Mc (mean ± SD), respectively. HXPE samples exhibited a significant (P < .01) wear rate reduction of 74% when compared with the CPE. Debris morphology trends between HXPE and CPE were consistent with what has been observed in other joint systems.
CONCLUSION: Use of HXPE significantly reduces wear of TAR as compared to CPE, based on in vitro wear testing.
CLINICAL RELEVANCE: Highly crosslinked polyethylene may reduce clinical complications of total ankle replacement that are linked to polyethylene wear.
METHODS: HXPE and CPE inserts within a semiconstrained, bicondylar TAR system were manufactured for this study. Samples were subjected to 5.0 million cycles of wear on an in vitro wear simulator. Testing was performed within a physiological environment, using kinematic and kinetic loading profiles characteristic of walking gait. Samples were weighed at regular intervals to determine gravimetric mass loss, and the morphology of wear particles was analyzed.
RESULTS: The wear rates for CPE and HXPE samples were 7.4 ± 1.3 and 1.9 ± 0.3 mg/Mc (mean ± SD), respectively. HXPE samples exhibited a significant (P < .01) wear rate reduction of 74% when compared with the CPE. Debris morphology trends between HXPE and CPE were consistent with what has been observed in other joint systems.
CONCLUSION: Use of HXPE significantly reduces wear of TAR as compared to CPE, based on in vitro wear testing.
CLINICAL RELEVANCE: Highly crosslinked polyethylene may reduce clinical complications of total ankle replacement that are linked to polyethylene wear.