Mechanical Strength of the Proximal Tibia Following Total Knee Arthroplasty: A Cadaveric Study of Resection Depth and Bone Density.

BACKGROUND

Tibial component failure has been a problem in total knee arthroplasty, it is still undetermined how tibial resection depth affects the strength to support a tibial component. This study examined the relationship between the resection depth and the bone density and the mechanical strength to support the tibial component.

MATERIALS AND

METHODS

Eight matched pairs of fresh, frozen cadaver lower legs were imaged with computed tomography to assess the bone density. A right tibia was resected at minimum resection level and a left tibia was resected at deep resection level. After the tibial component was implanted with cement on each tibia, it was loaded on a materials testing load frame to measure the stiffness and the load to failure.

RESULTS

The average bone density at the minimum resection level of the tibia was significantly higher than at deep level (p=0.0003). The average stiffness and load to failure of the proximal tibia were 1105 N/mm (range 889 to 1303 N/mm) and 5626 N (range 3360 to 9098 N). There was no statistical correlation between tibial resection depth and the axial stiffness (p=0.4107) or the load to failure (p=0.1487).

CONCLUSIONS

Although the bone density at a minimum resection level was higher than that at a deep level, the strength to support the tibial component was not statistically higher at a minimum cutting level than at a deeper cutting level proportionally. Surgeons may not need to minimize a proximal tibial bone resection to maintain a stronger support for a tibial component.