MedElevator Войти в исследования
← Поиск публикаций

DOI 10.3390/ma14226831

Медицинская библиотека · Materials (Basel, Switzerland) · 2021

Effect of Sandblasting on Static and Fatigue Strength of Flash Butt Welded 75Cr4 Bandsaw Blades.

Kubit Andrzej, Lenart Łukasz, Trzepieciński Tomasz, Krzysiak Andrzej, Łabuński Wojciech

СтатьяПеревод в очереди

Аннотация

The aim of the research presented in this article is analysis of the effect of the surface treatment method on the static and fatigue strength of flash butt welded bandsaw blades. A 1-mm-thick 75Cr1 cold-work tool steel sheet used for bandsaw blades was used as the test material. Fractographic studies of the fatigue fractures and fractures formed in static tests were also carried out. The static strength tests showed sandblasting the weld surface had no significant effect on the load capacity of the joint. However, the sandblasted specimens showed a higher repeatability of the load capacity (lower standard deviation). In the case of both analyzed sample variants of specimens, sandblasted and non-sandblasted, the number of cycles at which the sample was damaged decreases with the percentage increase of the stress amplitude. When loading the samples with a stress amplitude value in the range between 400 and 690 MPa, sandblasting of the weld surface increased the average value of destructive cycles by about 10-86% (depending on the stress amplitude) compared to non-sandblasted joints. The sandblasting process introduces compressive stresses in the surface layer of the welds, therefore the variable tensile load acting on the sample requires a greater number of cycles before the fatigue cracks initiate and propagate. In the case of all specimens, a ductile fracture was observed. It was also found that, regardless of the variable stress amplitude, sandblasting has a positive effect on reducing the standard deviation of fatigue test results.

Для цитирования: Kubit Andrzej, Lenart Łukasz, Trzepieciński Tomasz, Krzysiak Andrzej, Łabuński Wojciech. Effect of Sandblasting on Static and Fatigue Strength of Flash Butt Welded 75Cr4 Bandsaw Blades.. Materials (Basel, Switzerland). 2021. DOI: 10.3390/ma14226831.
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.