Dental materials : official publication of the Academy of Dental Materials · 2021
Pre-cementation procedures' effect on dental zirconias with different yttria content.
СтатьяНазвание и аннотация: Перевод в очереди
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Øilo Marit, Haugli Ketil, Rønold Hans Jacob, Ulsund Amanda H, Ruud Amund, Kvam Ketil
Аннотация
OBJECTVE: Several pre-cementation procedures have been advocated to enhance adhesion between zirconia and resin-based cement. There is, however, limited documentation on how these pre-treatments affect the strength of zirconia crowns as most tests are performed on discs or bars. The aim was to assess the effect of pre-cementation procedures on fracture mode, fracture strength and cement retention on zirconia.
METHODS: Two dental zirconia materials with different yttria content were assessed (<4 and>5 mol%). Both discs (n = 45) and crown-shaped specimens (n = 30) of the two materials were pretreated with either air-abrasion or hot-etching with KHF2 and compared with untreated controls with regards to surface roughness, crystallography, wettability, cement adhesion and fracture strength.
RESULTS AND SIGNIFICANCE: Air-abrasion improves adhesion and strength of zirconia with moderate yttria content (<4 mol%). Acid etching with heated KHF2 showed the best effect on strength and cement retention on zirconia with higher yttria content (>5 mol%). Application of KHF2 was, however, complicated on crown-shaped specimens. Pre-treatment and cementation protocols should be optimized for different dental zirconias to improve both strength and retention.
METHODS: Two dental zirconia materials with different yttria content were assessed (<4 and>5 mol%). Both discs (n = 45) and crown-shaped specimens (n = 30) of the two materials were pretreated with either air-abrasion or hot-etching with KHF2 and compared with untreated controls with regards to surface roughness, crystallography, wettability, cement adhesion and fracture strength.
RESULTS AND SIGNIFICANCE: Air-abrasion improves adhesion and strength of zirconia with moderate yttria content (<4 mol%). Acid etching with heated KHF2 showed the best effect on strength and cement retention on zirconia with higher yttria content (>5 mol%). Application of KHF2 was, however, complicated on crown-shaped specimens. Pre-treatment and cementation protocols should be optimized for different dental zirconias to improve both strength and retention.