MedElevator Войти в исследования
← Поиск публикаций

DOI 10.3390/ma14143799

Медицинская библиотека · Materials (Basel, Switzerland) · 2021

Effect of Small Amount of Ni Addition on Microstructure and Fatigue Properties of Sn-Sb-Ag Lead-Free Solder.

Yamamoto Mizuki, Shohji Ikuo, Kobayashi Tatsuya, Mitsui Kohei, Watanabe Hirohiko

СтатьяПеревод в очереди

Аннотация

The effect of the addition volume of Ni on the microstructures and tensile and fatigue properties of Sn-6.4Sb-3.9Ag (mass%) was investigated using micro-size specimens. The addition of Ni into Sn-6.4Sb-3.9Ag tends to increase the number of grains formed in the solidification process and produce a high-angle grain boundary. An amount of 0.1% proof stress of Sn-6.4Sb-3.9Ag decreases with an increase in the Ni addition volume at a strain rate of 2.0 × 10-1 s-1. The effect of the addition of Ni into Sn-6.4Sb-3.9Ag on tensile strength is negligible at both 25 °C and 175 °C. The elongation of Sn-6.4Sb-3.9Ag decreases with an increase in the Ni addition volume at 25 °C according to the fracture mode change from ductile chisel point fracture to shear fracture. The effect of the addition of Ni into Sn-6.4Sb-3.9Ag on the elongation is negligible at 175 °C. The low cycle fatigue test result shows that the fatigue life does not degrade even at 175 °C in all alloys investigated. The fatigue life of Sn-6.4Sb-3.9Ag-0.4Ni (mass%) is superior to those of Sn-6.4Sb-3.9Ag and Sn-6.4Sb-3.9Ag-0.03Ni (mass%) in the high cycle fatigue area. The electron back scattering diffraction (EBSD) analysis result shows that fine recrystallized grains are generated at the cracked area in Sn-6.4Sb-3.9Ag-0.4Ni in the fatigue test at 175 °C, and the crack progresses in a complex manner at the grain boundaries.

Для цитирования: Yamamoto Mizuki, Shohji Ikuo, Kobayashi Tatsuya, Mitsui Kohei, Watanabe Hirohiko. Effect of Small Amount of Ni Addition on Microstructure and Fatigue Properties of Sn-Sb-Ag Lead-Free Solder.. Materials (Basel, Switzerland). 2021. DOI: 10.3390/ma14143799.
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.