MedElevator Войти в исследования
← Поиск публикаций

DOI 10.2519/jospt.1997.25.1.3

Медицинская библиотека · The Journal of orthopaedic and sports physical therapy · 1997

The effect of fatigue on multijoint kinematics, coordination, and postural stability during a repetitive lifting test.

Sparto P J, Parnianpour M, Reinsel T E, Simon S

СтатьяПеревод в очереди

Аннотация

Because of the inability of strength tests to accurately discriminate between low back pain patients and healthy subjects, a multifactorial evaluation of low back pain patients is warranted. It is postulated that measurements of endurance, kinematics, postural stability, and coordination, in addition to strength, are necessary to fully document the patients' functional capabilities. This research study was conducted in order to understand the effects of fatigue on the above factors. Twelve healthy male subjects performed a repetitive lifting test in which a submaximal load was lifted at a maximal rate. Knee, hip, and trunk motion was measured using videography and electrogoniometry, postural stability was measured using a forceplate, and coordination parameters were determined using phase-plane analysis. Fatigue was documented by a 31% reduction in lifting power. At the end of the endurance test, there was less knee and hip range of motion and greater spine peak flexion, while the coordination measures demonstrated that there was greater hip and lumbar spine extension earlier in the lifting phase. The postural stability declined as the test endured. Utilization of these measures may guide physical therapists in their rehabilitation of low back pain patients.

Для цитирования: Sparto P J, Parnianpour M, Reinsel T E, Simon S. The effect of fatigue on multijoint kinematics, coordination, and postural stability during a repetitive lifting test.. The Journal of orthopaedic and sports physical therapy. 1997. DOI: 10.2519/jospt.1997.25.1.3.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.