DOI 10.1067/j.cpradiol.2019.04.004
Comparison of Magnetic Resonance Imaging and Ultrasonography in Diagnosing and Grading Carpal Tunnel Syndrome: A Prospective Study.
Аннотация
OBJECTIVE
To use anatomic measurements on magnetic resonance imaging (MRI) and ultrasonography (USG) in diagnosing and grading carpal tunnel syndrome (CTS) using nerve conduction studies (NCS) as the gold standard.
MATERIAL AND
METHODS
In this prospective study, 26 patients with CTS (45 wrists; 22 female and 4 male patients; mean ± SD age of 49.42 + 14.47 years) and 19 age and sex matched healthy volunteers (32 wrists; 15 female and 4 male volunteers, mean ± SD age of 42.52 + 10.85 years) underwent MRI and USG. Cross-sectional area (CA) of median nerve was measured using free hand ROI at four levels: hamate hook (H0), pisiform bone (PI0), 1 cm proximal (PI1) and 2 cm proximal to PI0 (PI2). Relative median nerve signal intensity (MNSI) was calculated as ratio of median nerve signal intensity with hypothenar muscle signal intensity. Flexor retinacular bowing was calculated at hamate hook level. Echogenicity and Power Doppler vascularity of median nerve were assessed on USG. Independent t-test, chi square test and receiver operating characteristic curve analysis were used as appropriate.
RESULTS
On USG, CA measured at PI0 (95% confidence interval of 0.872-0.987) and retinacular bowing (0.816-0.912), while, on MRI, CA at PI1 (0.874-0.997) were most useful in diagnosing CTS based on the ROC and Zombie plot analysis. Area under curves for CA measurements on USG and MRI were not significantly different. CA at PI1 on MRI (0.752-0.965) was significantly different between minimal to moderate CTS and severe to extreme CTS groups (on NCS).
CONCLUSION
CA of median nerve is the most useful parameter to diagnose and grade CTS and USG and MRI are comparable for measurements. Increased retinacular bowing on USG and hypoechogenicity of median nerve increase the diagnostic confidence while MRI helps in picking up important associated conditions.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.