DOI 10.1016/j.burns.2024.08.012
Clinical comparison study of square flap method and five-flap Z-plasty technique for correction of post-burn axillary contractures: Analysis of length gain and evaluation of functional outcome.
Аннотация
INTRODUCTION
While there is no consensus on the best surgical procedure for post-burn axillary contractures, it is crucial to consider the elongation rate along the scar axis as a useful measurement index for determining the optimal surgical approach. The square flap and five flap z-plasty techniques are commonly employed scar lengthening procedures to address scar contractures in the axilla. These approaches successfully disrupt the linear scar, leading to significant elongation while reducing transverse tension. Our study aims to compare the increase in band length and functional results of these two approaches for treating post-burn contractures in the axilla.
METHODS
A retrospective study was carried out utilizing data from 34 patients with mild-to-moderate band-like contractures located on the anterior or posterior axillary lines who underwent surgical correction through either the square flap method or five-flap z-plasty technique. The effectiveness of surgical methods was evaluated using two objective indices: improvement in contracture band length and improvement in abduction angle at the shoulder joint.
RESULTS
All patients achieved complete contracture release. There is no statistically significant difference between the two groups regarding the improvement in the degree of abduction postoperatively. Although there was a significant increase in the length of the contracture band postoperatively in both groups, the average increase in length for cases treated with a square flap was significantly greater than those managed with a five-flap Z-plasty (87.7 ± 44.8 % vs. 38.80 ± 11.119 %,) respectively.
CONCLUSION
The square flap technique is considered a better alternative to the commonly used 5-flap Z-plasty method because it can achieve higher elongation in the contracture band, restore joint function, and create optimal shape when dealing with single linear band contractures over the axilla.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.