MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1007/s00404-020-05551-0

Медицинская библиотека · Archives of gynecology and obstetrics · 2020

Comparison of aspirating pipettes and hysteroscopy with curettage.

Piriyev E, Mellin W, Römer T

СтатьяПеревод в очереди

Аннотация

PURPOSE: In this prospective study, endometrial biopsy by pipette was compared with hysteroscopy with curettage in patients with an abnormal uterine bleeding (ABU) (hypermenorrhea, intermediate bleeding, continuous bleeding, postmenopausal bleeding) and patients with a sonographically abnormal endometrium.

METHODS

176 patients were included. The pipette samples were taken during the usual planned procedure under general anaesthesia. Thereafter, the planned hysteroscopy with curettage was completed. The study was performed as a double-blind study. The obtained histologies (of pipelle and curettage) were sent separately to the same pathologist. The pipelle material was encoded by a specific number without any patient data.

RESULTS

In 97% of the cases using the biopsy with pipette were obtained an adequate sample. The biopsy with pipette had a sensitivity and specificity of 100% in the diagnosis of endometrial carcinoma and atypical hyperplasia. Pipette showed a significantly lower accuracy with a sensitivity of 28% in the diagnosis of endometrial hyperplasia without atypia. Pipette showed the lowest sensitivity for polyps, myomas and atrophic endometrium.

CONCLUSION

The study shows that pipette sampling is a safe, accurate, low-cost ambulatory procedure with high sensitivity for the detection of atypical endometrial hyperplasia and endometrial carcinoma. In the case of sonographically definable findings (polyp, myoma), hysteroscopy with curettage is preferred.

Для цитирования: Piriyev E, Mellin W, Römer T. Comparison of aspirating pipettes and hysteroscopy with curettage.. Archives of gynecology and obstetrics. 2020. DOI: 10.1007/s00404-020-05551-0.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.