Journal of Indian Prosthodontic Society · 2026
Impact of repeated usage of two different scan bodies on the accuracy of implant position transfer: An in vitro study.
СтатьяСравнительное исследованиеНазвание и аннотация: Перевод в очереди
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Shinde Koustubh Sharadkumar, Raghavendra Prasad S, Chethana K
Аннотация
AIM: To evaluate and compare the effect of repeated sterilization cycles on linear, angular, and diameter changes, and overall implant position transfer accuracy of titanium and polyetheretherketone (PEEK) scan bodies.
SETTINGS AND DESIGN: An in vitro study.
MATERIALS AND METHODS: An in vitro study was conducted using two maxillary acrylic models with implant analogues. Titanium and PEEK scan bodies were scanned using an intraoral scanner, with the initial scan serving as the reference. Each scan body underwent 14 steam autoclave cycles (134°C for 10 min followed by 15 min drying). Scans were exported as STL files and superimposed onto the reference dataset. Linear, angular, diameter, and root mean square (RMS) deviations were measured.
STATISTICAL ANALYSIS USED: Data were analyzed using repeated measures analysis of variance (ANOVA). Mean differences with 95% confidence intervals were calculated, and statistical significance was set at P < 0.05.
RESULTS: Both materials showed deviations after repeated sterilization; however, titanium scan bodies exhibited significantly lower linear, angular, and RMS deviations. PEEK demonstrated greater variability and dimensional changes.
CONCLUSION: Repeated sterilization affects scan body accuracy in a material-dependent manner. Titanium scan bodies showed superior dimensional stability and more consistent implant position transfer than PEEK.
SETTINGS AND DESIGN: An in vitro study.
MATERIALS AND METHODS: An in vitro study was conducted using two maxillary acrylic models with implant analogues. Titanium and PEEK scan bodies were scanned using an intraoral scanner, with the initial scan serving as the reference. Each scan body underwent 14 steam autoclave cycles (134°C for 10 min followed by 15 min drying). Scans were exported as STL files and superimposed onto the reference dataset. Linear, angular, diameter, and root mean square (RMS) deviations were measured.
STATISTICAL ANALYSIS USED: Data were analyzed using repeated measures analysis of variance (ANOVA). Mean differences with 95% confidence intervals were calculated, and statistical significance was set at P < 0.05.
RESULTS: Both materials showed deviations after repeated sterilization; however, titanium scan bodies exhibited significantly lower linear, angular, and RMS deviations. PEEK demonstrated greater variability and dimensional changes.
CONCLUSION: Repeated sterilization affects scan body accuracy in a material-dependent manner. Titanium scan bodies showed superior dimensional stability and more consistent implant position transfer than PEEK.