MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1016/j.thromres.2013.10.001

Медицинская библиотека · Thrombosis research · 2013

New observations on procoagulant properties of amniotic fluid: microparticles (MPs) and tissue factor-bearing MPs (MPs-TF), comparison with maternal blood plasma.

Uszyński Waldemar, Zekanowska Ewa, Uszyński Mieczysław, Zyliński Andrzej, Kuczyński Jarosław

СтатьяПеревод в очереди

Аннотация

INTRODUCTION

Microparticles (MPs) are submicron fragments of the cell membrane affecting many biological processes, e.g. coagulation. The aim of the study was to determine (i) MPs and (ii) tissue factor bearing MPs (MPs-TF) in the amniotic fluid and in blood plasma of parturient women, as well as to assess (iii) TF and TFPI.

MATERIAL AND

METHODS

The study group consisted of 38 women laboring at term, whereas the control group included 20 non-pregnant women. ELISA method was used to evaluate MPs, MPs-TF, TF and TFPI.

RESULTS

The levels of MPs and MPs-TF were significantly higher in the amniotic fluid than in blood plasma of parturient women: the level of MPs was 41.08 times higher (medians: 246.48 nM PS vs. 6.00 nM PS, respectively, p<0.001), and the level of MPs-TF was 18.59 times higher (medians: 90.16pg/ml vs. 4.85pg/ml, respectively) (p<0.001).

CONCLUSIONS

1. Microparticles (MPs) and tissue factor-bearing MPs (MPs-TF) are constituent components of amniotic fluid. 2. It is reasonable to assume that these components together with tissue factor (TF) and its inhibitor (TFPI) can participate in life-threatening coagulation disturbances in amniotic fluid embolism, and to take into consideration their impact on fetal development.

Для цитирования: Uszyński Waldemar, Zekanowska Ewa, Uszyński Mieczysław, Zyliński Andrzej, Kuczyński Jarosław. New observations on procoagulant properties of amniotic fluid: microparticles (MPs) and tissue factor-bearing MPs (MPs-TF), comparison with maternal blood plasma.. Thrombosis research. 2013. DOI: 10.1016/j.thromres.2013.10.001.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.