Strategies for Safe Transurethral Injections of Botulinum Toxin into the Bladder Wall.

Introduction

Transurethral injections into the bladder wall with botulinum toxin are an established treatment for refractory overactive bladder or detrusor overactivity. With the current injection technique, an average of approx. 18% and up to 40% of botulinum toxin is injected next to the bladder wall, potentially causing reduced efficacy or non-response. The article aims to evaluate the reasons for incorrect injections and propose strategies for complete delivery of the entire botulinum toxin fluid into the bladder wall. Material and

Methods

Unstructured literature search and narrative review of the literature.

Results

Incorrect injection of botulinum toxin fluid next to the bladder wall is caused by pushing the injection needle too deep and through the bladder wall. Bladder wall thickness decreases with increasing bladder filling and has a thickness of less than 2 mm beyond 100 mL in healthy individuals. Ultrasound imaging of the bladder wall before botulinum toxin injection can verify bladder wall thickness in individual patients. Patient movements during the injection therapy increase the chance of incorrect placement of the needle tip.

Conclusions

Based on the literature search, it is helpful and recommended to (1) perform pretreatment ultrasound imaging of the bladder to estimate bladder wall thickness and to adjust the injection depth accordingly, (2) fill the bladder as low as possible, ideally below 100 mL, (3) use short needles, ideally 2 mm, and (4) provide sufficient anesthesia and pain management to avoid patient movements during the injection therapy.