DOI 10.1590/s1677-5538.ibju.2021.0499
A novel upper tract ureteroscopic biopsy technique: the "form tackle".
Аннотация
INTRODUCTION AND
OBJECTIVE
Upper tract urothelial carcinoma (UTUC) represents 5% of all urothelial malignancies (1-3). Accurate pathologic diagnosis is key and may direct treatment decisions. Current ureteroscopic biopsy techniques include cold-cup, backloaded cold-cup and stone basket (4-6). The study objective was to compare a standard cold-cup biopsy technique to a novel cold-cup biopsy technique and evaluate histopathologic results.
MATERIALS AND
METHODS
We developed a novel UTUC biopsy technique termed the "form tackle" biopsy. Ureteroscope is passed into ureter/renal collecting system. Cold-cup forceps are opened and pressed into the lesion base (to engage the urothelial wall/submucosal tissue) then closed. Ureteroscope/forceps are advanced forward 3-10mm and then extracted from the patient. We compared standard versus novel upper tract biopsy techniques in a series of patients with lesions ≥1cm. In each procedure, two standard and two novel biopsies were obtained from the same lesion. The primary study aim was diagnosis of malignancy. IRB approved: 21-006907.
RESULTS
Fourteen procedures performed on 12 patients between June 2020 and March 2021. Twenty-eight specimens sent (14 standard, 14 novel) (Two biopsies per specimen). Ten procedures with concordant pathology. In 4 procedures the novel biopsy technique resulted in a diagnosis of UTUC (2 high-grade, 2 low-grade) in the setting of a benign standard biopsy. Significant difference in pathologic diagnoses was detected between standard and novel upper tract biopsy techniques (p=0.008).
CONCLUSIONS
The "form tackle" upper tract ureteroscopic biopsy technique provides higher tissue yield which may increase diagnostic accuracy. Further study on additional patients required. Early results are encouraging.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.