MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1016/j.ejpb.2015.03.008

Медицинская библиотека · European journal of pharmaceutics and biopharmaceutics : official journal of Arbeitsgemeinschaft fur Pharmazeutische Verfahrenstechnik e.V · 2015

Partition coefficient vs. binding constant: How best to assess molecular lipophilicity.

Cevc Gregor

Сравнительное исследованиеСтатьяПеревод в очереди

Аннотация

Partition coefficient, P, is the preferred descriptor of molecular lipo- or hydrophilicity, and thus of relationships between a solute (S, e.g., a drug), a polar medium (W, e.g., an aqueous buffer), and an essentially apolar, organic, medium or a drug carrier (O). The coefficient is commonly identified with the linear ratio of solute quantities in the two media, P=nSO/nSW, even to characterise solute association with or binding to a surface (e.g., of a HPLC column or a drug carrier). To check the latter practice correctness-and credibility of the prevailing P definition-this paper compares an ideal solute distribution between two separate homogeneous fluid media (i.e., partitioning) to solute association with a uniform surface immersed in one such medium (i.e., binding). This reveals that solute partitioning and binding fundamentally differ and can only exceptionally be described, or analysed, with similar equations. Nonlinearised formulae that describe partitioning (Eq. (9)) and binding (Eq. (11)) can yield similar lipophilicity descriptor values only if solute preparation is relatively dilute; employing a large organic medium fraction is helpful in this respect. Additional prerequisites for partitioning and binding models match are: 1:1 stoichiometry at the association maximum and identical interfacial area of solute and organic medium molecules. If these requirements are not met, binding model yields different, potentially somewhat higher, but more often up to >10 times lower results than partitioning model. The main reason is saturation of organic medium with solute molecules. Partitioning model excludes this phenomenon, which cannot always be prevented by focussing on dilute solute preparations. The current practice of using a linear model and approximate equations to study partitioning or binding can cause large errors (>10(3)×), and is one possible reason for the notoriously high experimental logP values scattering. The latter makes logP predictions more difficult and less reliable than they could be if the measured data were evaluated with non-linearised partitioning or binding equations, as appropriate.

Для цитирования: Cevc Gregor. Partition coefficient vs. binding constant: How best to assess molecular lipophilicity.. European journal of pharmaceutics and biopharmaceutics : official journal of Arbeitsgemeinschaft fur Pharmazeutische Verfahrenstechnik e.V. 2015. DOI: 10.1016/j.ejpb.2015.03.008.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.