Development of fenofibrate solid dispersion via hot melt extrusion and 3D printing technologies.

This study aimed to develop an amorphous solid dispersion (ASD) of fenofibrate using Hot Melt Extrusion (HME) and 3D printing to evaluate the impact of preparation methods on ASD properties. Fenofibrate (10% w/w) was processed with Soluplus® and Polyethylene oxide-N80 to produce HME filaments. These filaments were either used as feedstock for Fused Deposition Modeling (FDM) 3D printing to fabricate tablets with 90%, 70%, and 50% infill densities or milled and filled into gelatin capsules. Printability was assessed via a three-point bend test. The fenofibrate formulations were evaluated for drug content, physical state, surface morphology, and release profile. The SEM images of pure fenofibrate showed large cylindrical crystals while the 3D-printed tablets showed a smooth surface with no record of any crystals. This observation is in line with the DSC results and confirms the conversion of fenofibrate from crystalline to an amorphous state. The in- vitro drug release for the 3D printed tablets and capsules was increased 2-fold as compared to pure fenofibrate. Statistical comparisons further supported these findings, highlighting infill density as a tunable parameter for modulating release kinetics.