MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1016/j.ejogrb.2012.07.032

Медицинская библиотека · European journal of obstetrics, gynecology, and reproductive biology · 2012

Effect of blood and mucus on the success rates of embryo transfers.

Tiras Bulent, Korucuoglu Umit, Polat Mehtap, Saltik Ayse, Zeyneloglu Hulusi Bulent, Yarali Hakan

СтатьяПеревод в очереди

Аннотация

OBJECTIVES

To provide information about the effects of blood and mucus on the embryo transfer (ET) catheters after transfer on embryo transfer outcomes.

STUDY

DESIGN

Retrospective analysis of 8311 ultrasound-guided embryo transfers performed in a single center. In 6897 cases (82.9%), there were no blood on the catheter after ET, 1168 transfers were associated with mild blood (14.1%), 33 transfers with moderate blood (0.4%) and 213 transfers with severe blood (2.6%). A total of 6162 transfer catheters were free of mucus (74.8%), whereas mucus was detected on 2081 catheters (25.2%).

RESULTS

The implantation rate (IR) was highest in the group with no blood on the transfer catheter, and lowest in the group with severe blood on the catheter. The clinical pregnancy rate (CPR) was lowest in the group with severe blood on the catheter. The presence of mucus on the catheter was found to have no effect on IR, CPR, biochemical pregnancy rates, miscarriage rates and live birth rates.

CONCLUSIONS

This study showed decreased IR, CPR and live birth rates in ETs associated with blood on the catheter. Mucus on the catheter appeared to be a simple contamination in this study and pregnancy rates remained unaffected.

Для цитирования: Tiras Bulent, Korucuoglu Umit, Polat Mehtap, Saltik Ayse, Zeyneloglu Hulusi Bulent, Yarali Hakan. Effect of blood and mucus on the success rates of embryo transfers.. European journal of obstetrics, gynecology, and reproductive biology. 2012. DOI: 10.1016/j.ejogrb.2012.07.032.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.