MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1016/j.foodchem.2015.01.008

Медицинская библиотека · Food chemistry · 2015

Separation and preconcentration of Cu(II), Pb(II), Zn(II), Fe(III) and Cr(III) ions with coprecipitation method without carrier element and their determination in food and water samples.

Mendil Durali, Karatas Murat, Tuzen Mustafa

Оценочное исследованиеСтатьяПоддержка исследования: вне правительства СШАПеревод в очереди

Аннотация

In this study, Cu(II), Pb(II), Zn(II), Fe(III) and Cr(III) were determined in some food and water samples after development 2,9-dimethyl-4,7-diphenyl-1,10-phenanthroline (BCP) coprecipitation procedure using flame atomic absorption spectrometry (FAAS). Effects of some analytical parameter including pH, sample volume, reagent amount, centrifuge rate and time, etc. on the presented coprecipitation system were studied for the quantitative recoveries of Cu(II), Pb(II), Zn(II), Fe(III) and Cr(III) ions. The influences of matrix ions were examined. The recovery values for analyte ions were calculated ⩾ 95%. The relative standard deviation was found 8.0% and the preconcentration factor was found as 25 for all analyte ions. The detection limits (k=3, N=21) were found to be as 0.80 μg L(-1) Cu(II), 3.08 μg L(-1) Pb(II), 0.28 μg L(-1) Zn(II), 0.91 μg L(-1) Fe(III) and 1.82 μg L(-1) Cr(III). NIST SRM 1515 Apple leaves and GBW-07605 Tea certified reference materials were used to confirm the accuracy of the method. The simultaneous coprecipitation method was applied to various water and microwave digested food samples.

Для цитирования: Mendil Durali, Karatas Murat, Tuzen Mustafa. Separation and preconcentration of Cu(II), Pb(II), Zn(II), Fe(III) and Cr(III) ions with coprecipitation method without carrier element and their determination in food and water samples.. Food chemistry. 2015. DOI: 10.1016/j.foodchem.2015.01.008.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.