MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1016/j.jhsa.2005.03.006

Медицинская библиотека · The Journal of hand surgery · 2005

Volar fixation of dorsally displaced distal radius fractures using the 2.4-mm locking compression plates.

Musgrave Douglas S, Idler Richard S

СтатьяПеревод в очереди

Аннотация

PURPOSE: To determine whether volar fixed-angle plate fixation with a new plate system could be used to treat dorsally unstable distal radius fractures. We hypothesized that volar fixed-angle plate fixation with or without radial styloid fixed-angle plate fixation would provide sufficient rigidity to allow early active range of motion without compromising fracture reduction. The initiation of early active motion may improve functional outcomes.

METHODS

A retrospective review was conducted of one institution's initial experience using a new volar fixed-angle plate system to treat dorsally displaced intra-articular and extra-articular distal radius fractures. Thirty-two fractures in 32 patients with dorsally displaced distal radius fractures were treated with a volar fixed-angle plate with or without a radial styloid fixed-angle plate. Fractures were classified using the AO classification. Radiographic parameters on preoperative, postoperative, and final follow-up radiographs were compared. The time to initiation of active range of motion was determined. Final follow-up ranges of motion and complications were reported. Finally, comparisons were made between the 23 fractures treated with a volar plate alone and the 9 fractures treated with a volar plate and a radial styloid plate.

RESULTS

The average follow-up period was 13 months. Two thirds of the fractures were intra-articular. Average loss of reduction from initial postoperative to final follow-up radiographs was 0 degrees of volar tilt, 1 degrees of radial inclination, and 0 mm of radial length. Active wrist and forearm ranges of motion were initiated at an average of 11 days after surgery. The final follow-up flexion-extension and pronation-supination arcs averaged 112 degrees and 151 degrees , respectively. The 9 fractures treated with the combination of a fixed-angle volar plate with a fixed-angle radial styloid plate had greater initial displacement than did the 23 fractures treated with a volar plate alone. Otherwise, differences between the 2 groups were not significant. Only 1 radial styloid plate became symptomatic.

CONCLUSIONS

Volar plate fixation using a new fixed-angle plate system successfully can stabilize dorsally unstable distal radius fractures. Early active range of motion was facilitated without compromising fracture reduction.

Для цитирования: Musgrave Douglas S, Idler Richard S. Volar fixation of dorsally displaced distal radius fractures using the 2.4-mm locking compression plates.. The Journal of hand surgery. 2005. DOI: 10.1016/j.jhsa.2005.03.006.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.