MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1099/jmm.0.001073

Медицинская библиотека · Journal of medical microbiology · 2019

Evaluation of inhibitor-combination mCIM for detecting MBL-producing Enterobacterales using three MBL inhibitors.

Yamada Kageto, Sasaki Masakazu, Imai Waka, Murakami Hinako, Morita Toshisuke, Aoki Kotaro, Ishii Yoshikazu, Tateda Kazuhiro

СтатьяПеревод в очереди

Аннотация

The increase in carbapenemase-producing Enterobacterales (CPE), including metallo-β-lactamase (MBL) producers, is a severe global health concern. Thus, highly sensitive and specific methods for detecting MBL producers are needed. In this study, we tested the detectability of MBL-producing Enterobacterales against three types of MBL inhibitors (sodium mercaptoacetate, SMA; ethylenediaminetetraacetic acid, EDTA; and dipicolinic acid, DPA) used in combination with a modified carbapenem inactivation method (mCIM). These inhibitor-combination mCIMs were tested against 129 CPE (IMP, 93; NDM, 11; KPC, 13; NMC, 1; OXA-48, 11) and 75 non-CPE. For evaluation of MBL inhibitors, we used two concentrations for each of the three inhibitors: DPA (200 and 300 mg l- 1), EDTA (5 and 10 mM), and SMA (1500 and 3000 mg l- 1). The overall sensitivities of SMA, EDTA and DPA were 97.1-99.0 %, 81.7-99.0 % and 88.5-96.2 %, respectively. Moreover, each method showed high specificity (99.0-100 %). Although inhibitor-combination mCIMs were highly sensitive and specific for the detection of MBL producers, we found that sensitivity was dependent on the concentration of inhibitors.

Для цитирования: Yamada Kageto, Sasaki Masakazu, Imai Waka, Murakami Hinako, Morita Toshisuke, Aoki Kotaro, Ishii Yoshikazu, Tateda Kazuhiro. Evaluation of inhibitor-combination mCIM for detecting MBL-producing Enterobacterales using three MBL inhibitors.. Journal of medical microbiology. 2019. DOI: 10.1099/jmm.0.001073.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.