Chelating ionophore based membrane sensors for copper(II) ions.

Acetylacetone, ethylacetoacetate and salicyldehyde, are reported to form chelates with copper of high stability as compared to other metals. Therefore, PVC based membranes of bis[acetylacetonato] Cu(II) (A), bis[ethylacetoacetate] Cu(II) (B) and bis[salicyldehyde] Cu(II) (C) have been investigated as copper(II) selective sensors. The addition of sodium tetraphenylborate and various plasticizers, viz., DOS, TEHP, DOP, DBP and TBP have been found to substantially improve the performance of the sensors. The membranes of various compositions of the three chelates were investigated and it was found that the best performance was obtained for the membrane of composition A (1%): PVC (33%): TBP (65%): NaTPB (1%). The sensor shows a linear potential response to Cu(II) over wide concentration range 2.0x10(-6) to 1.0x10(-1)M (detection limit approximately 0.1ppm) with Nernstian compliance (29.3mVdecade(-1) of activity) between pH 2.6 and 6.0 with a fast response time of approximately 9s. The potentiometric selectivity coefficient values as determined by match potential method (MPM) indicate excellent selectivity for Cu(2+) ions over interfering cations. The sensor exhibits adequate shelf life ( approximately 3 months) with good reproducibility (S.D. +/-0.2mV). The sensor has been used in the potentiometric titration of Cu(2+) with EDTA. The utility of the sensor has been tested by determining copper in vegetable foliar and multivitamin capsule successfully.