Three-Dimensional Printing of Reduction Template in the Contouring of Craniofacial Fibrous Dysplasia.

BACKGROUND

Contouring is a minimal invasive procedure to remove excess lesions and restore facial appearance of patients with craniofacial fibrous dysplasia; however, it is difficult to measure the amount of excess lesions. This study is to demonstrate the use of reduction template produced by three-dimensional printer in contouring procedure.

METHODS

Computed tomography data were reconstructed into a three-dimensional model by Mimics software. The unaffected side was mirrored and superimposed on the affected side. Excess fibrous dysplasia lesions were calculated by Boolean operations. Lesions to be removed were separated and saved as stereolithography file. This model was further constructed in 3-matic package of Mimics software, and several holes were designed to indicate the variation in depth. Finally, the virtual model was exported into three-dimensional printer to produce physical template.

RESULTS

With the direct guidance of three-dimensional reduction template, contouring procedure was performed easily and accurately. Good facial symmetry was achieved with reduced operative time and loss of bleeding.

CONCLUSIONS

The application of reduction template produced by three-dimensional printer in contouring procedure improves the efficient and safety of surgery. Good outcomes are obtained without extra requirement in craniofacial surgery.