[Investigation on dermal contamination among workers occupationally exposed to dimethylformamide].

OBJECTIVE

To establish a method for the determination of dimethylformamide (DMF) and investigate dermal contamination and absorption among workers occupationally exposed to DMF.

METHOD: 37 workers exposed to DMF were divided randomly into two groups. DMF was washed down by isopropyl alcohol in A group (16 workers) and water in B group(21 workers).Gas chromatography was used for the quantification of dermal contamination and N-methylformamide(NMF) in urine, correlative study was done between them.

RESULTS

DMF could be detected in all samples in A group, but could not be detected in B group. The miscellaneous peaks could be completely separated from the DMF peak in the sample spectrum, without manual inference. The highest degree of total dermal contamination was observed in wet spinning workshop [(2.84 +/- 1.31) mg], postprocessing workshop [(2.50 +/- 0.95) mg] and dry spinning workshop [(1.95 +/- 0.61) mg] were lower. The respiratory cumulative exposure dosages were 351.3, 201.3 and 135.2 mg respectively. The average DMP concentration in air of the third printing processing workshop, the dry spinning workshop and the wet spinning workshop was 60.2, 89.6, 156.4 mg/m3 respectively, and the respiratory tract contamination in the workers of the three workshops were 135.2, 201.3 and 351.3 mg respectively. There was statistical independence between the quantification of total dermal contamination and NMF in urine (r = 0.176, P > 0.05).

CONCLUSION

Isopropyl alcohol is the effective washing solvent.When the concentration of DMF in workplace air is above the occupational exposure limit, respiratory tract absorption is the principal pathway of DMF absorption,but dermal contamination of DMF should not be ignored.