Cesium removal from a water system using a polysulfone carrier containing nitric acid-treated bamboo charcoal.

Laboratory scale sorption and desorption experiments were performed to investigate the cesium (Cs) removal efficiency of a bead-shaped polysulfone carrier containing HNO3-treated bamboo charcoal (BC). The average Cs removal efficiency of BC only and of polysulfone carrier without BC after 1 h sorption reaction was 53 and 18%, respectively. However, the Cs removal efficiency for the polysulfone carrier with 5% HNO3-treated BC (P-5N-BC) after 1 h and 24 h reaction was 66 and 98%, respectively. The Cs removal efficiency after 24 h reaction remained >85% over a wide range of pH and temperature conditions, suggesting that using P-5N-BC as the Cs adsorbent is feasible in a variety of aquatic environments. The maximum Cs sorption capacity (qm) of P-5N-BC, as calculated from a Langmuir isotherm model, was 60.9 mg/g, which is much higher than those of other adsorbents from previous studies for 1 h of sorption time. The Cs desorption rate of P-5N-BC for 24 h desorption time was <17%, showing that the Cs was stably enough attached to the HNO3-treated BC for long-term use. The results of continuous column experiments showed that the total amount of treated water from the column packed with P-5N-BC increased more than nine times when compared with that from the only BC-granule-packed column. The P-5N-BC maintained more than 68% Cs removal efficiency after 90 pore volumes of flushing, suggesting that only 15 g of P-5N-BC (with only 0.75 g of HNO3-treated BC) could clean 5 L of Cs-contaminated water (initial Cs concentration: 1.0 mg/L; effluent concentration: < 0.09 mg/L). The present results demonstrate that P-5N-BC has remarkable potential for removal of Cs from diverse water systems.