MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1002/jssc.201600324

Медицинская библиотека · Journal of separation science · 2016

A validated stability-indicating ultra performance liquid chromatography method for the determination of potential process-related impurities in eplerenone.

Du Mingluo, Pan Chunyan, Chen Jing, Song Min, Zhu Tingting, Hang Taijun

СтатьяВалидационное исследованиеПеревод в очереди

Аннотация

A simple, sensitive, and accurate stability-indicating analytical method has been developed and validated using ultra high performance liquid chromatography. The developed method is used to evaluate the related substances of eplerenone (EP). The degradation behavior of EP under stress conditions was determined, and the major degradants were identified by ultra high performance liquid chromatography with tandem mass spectrometry. The chromatographic conditions were optimized using an impurity-spiked solution, and the samples, generated from forced degradation studies. The resolution of EP, its potential impurities, and its degradation products was performed on a Waters UPLC BEH C18 column (50 × 2.1 mm, 1.7 μm) by linear gradient elution using a mobile phase consisting of 10 mmol/L ammonium acetate adjusted to pH 4.5, methanol and acetonitrile. A photo-diode array detector set at 245 nm was used for detection. The flow rate was set at 0.3 mL/min. The procedure had good specificity, linearity (0.02-3.14 μg/mL), recovery (96.1-103.9%), limit of detection (0.01-0.02 μg/mL), limit of quantitation (0.03-0.05 μg/mL), and robustness. The correction factors of the process-related substances were calculated.

Для цитирования: Du Mingluo, Pan Chunyan, Chen Jing, Song Min, Zhu Tingting, Hang Taijun. A validated stability-indicating ultra performance liquid chromatography method for the determination of potential process-related impurities in eplerenone.. Journal of separation science. 2016. DOI: 10.1002/jssc.201600324.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.