Additively Manufactured Mechanically Tunable Cavity Resonator for Broadband Characterization of Liquid Permittivity.

This paper presents the design, fabrication, and experimental validation of a metal 3D-printed mechanically tunable cavity resonator operating in the hybrid TM-coaxial resonant mode for the broadband characterization of liquid permittivity. The proposed structure was developed based on a cylindrical cavity by incorporating a disc-terminated metallic tuning stub, which enables continuous frequency adjustment from 0.5 GHz to 3.0 GHz while maintaining a maximum unloaded Q-factor of 284 at 1 GHz under air-filled conditions. The tuning mechanism allows for precise frequency selection for characterizing materials exhibiting frequency-dependent permittivity. To demonstrate its sensing capability, the resonator was applied to characterize ethanol-water mixtures, where resonant frequency shifts were correlated with ethanol concentration at representative baseline frequencies of 1.00 GHz, 2.00 GHz, and 2.94 GHz. The sensor achieved frequency/dielectric constant resolutions of 0.39, 1.34, and 4.20 MHz and average concentration errors of 1.25%, 3.73%, and 2.49%, respectively. Moreover, polynomial fitting models enabled the accurate extraction of dielectric constants with an average deviation below 0.5% compared with a commercial dielectric probe system. The combination of frequency tunability, compact geometry, and compatibility with additive manufacturing establishes the proposed cavity resonator as a versatile platform for broadband dielectric spectroscopy, chemical sensing, and liquid characterization.