MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1053/j.jvca.2012.03.011

Медицинская библиотека · Journal of cardiothoracic and vascular anesthesia · 2012

An evaluation of factors affecting activated coagulation time.

Bosch Yvonne P J, Weerwind Patrick W, Nelemans Patty J, Maessen Jos G, Mochtar Baheramsjah

СтатьяПеревод в очереди

Аннотация

OBJECTIVE

Although failure to achieve an adequate activated coagulation time (ACT) after full heparinization before cardiopulmonary bypass often is attributed to antithrombin (AT) deficiency, it remains unclear if this is a causative mechanism of decreased heparin responsiveness. Therefore, the authors determined the relationship between AT and other coagulation-related factors that affect the ACT measurement and heparin sensitivity index before the establishment of cardiopulmonary bypass.

DESIGN

Observational study.

SETTING

University medical center.

PARTICIPANTS

Adult elective cardiac surgical patients.

INTERVENTIONS: Preoperative data collection included demographics, type of preoperative medical therapy, hemoglobin, platelet count, and AT. Intraoperative measurements included ACT and anti-Xa activity.

RESULTS

Of the 203 patients enrolled in this study, 10% (n = 21) did not achieve an adequate ACT (≥400 seconds) after full heparinization. Subnormal AT activity (55%-79%) was not related to a low ACT and a low heparin sensitivity index. Preoperative low-molecular-weight heparin therapy did not cause a decreased ACT response. However, preoperative low hemoglobin levels and high platelet counts were associated with a decreased ACT.

CONCLUSIONS

All these observations suggest that failure to achieve an adequate ACT is, in general, not an indicator of AT deficiency but could be affected by high platelet counts and low hemoglobin levels.

Для цитирования: Bosch Yvonne P J, Weerwind Patrick W, Nelemans Patty J, Maessen Jos G, Mochtar Baheramsjah. An evaluation of factors affecting activated coagulation time.. Journal of cardiothoracic and vascular anesthesia. 2012. DOI: 10.1053/j.jvca.2012.03.011.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.