Journal of orthopaedic trauma · 2011
Biomechanical comparison of locking versus nonlocking volar and dorsal T-plates for fixation of dorsally comminuted distal radius fractures.
Сравнительное исследованиеОценочное исследованиеСтатьяПоддержка исследования: вне правительства СШАНазвание и аннотация: Перевод в очереди
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Gondusky Joseph S, Carney Joseph, Erpenbach Jonathan, Robertson Claire, Mahar Andrew, Oka Richard, Thompson Michael, Mazurek Michael
Аннотация
OBJECTIVES: The purpose of this study was to gain insight into the effect of plate location and screw type for fixation of extra-articular distal radius fractures with dorsal comminution (Orthopaedic Trauma Association Type 23-A3.2).
METHODS: Sixteen pairs of cadaver radii were randomized to four plating configurations: dorsal locking, dorsal nonlocking, volar locking, and volar nonlocking. A standard 1-cm dorsal wedge osteotomy was used. Cyclic axial loads were applied for 5000 cycles. Stiffness and fragment displacement were recorded at 500 cycle-intervals. Pre- and postcyclic loading radiographs were analyzed. An axial load to failure test followed and construct stiffness and failure strength recorded. Biomechanical data were analyzed using a two-way analysis of variance (P < 0.05). Failure modes were descriptively interpreted.
RESULTS: Cyclic testing data revealed no difference between constructs at any interval. Within all construct groups, displacement that occurred did so within the first 500 cycles of testing. Pre- and postcyclic loading radiographic analysis showed no differences in construct deformation. Load to failure testing revealed no differences between groups, whereas volar constructs approached significance (P = 0.08) for increased failure strength. Dorsal constructs failed primarily by fragment subsidence and fragmentation, whereas volar constructs failed by plate bending.
CONCLUSIONS: No difference in all measured biomechanical parameters supports equivalence between constructs and surgeon discretion in determining operative method. Minimal fragment displacement and construct deformation during physiological testing support previous data that early postoperative motion can be recommended. Fragment displacement that occurs does so in the early periods of motion.
METHODS: Sixteen pairs of cadaver radii were randomized to four plating configurations: dorsal locking, dorsal nonlocking, volar locking, and volar nonlocking. A standard 1-cm dorsal wedge osteotomy was used. Cyclic axial loads were applied for 5000 cycles. Stiffness and fragment displacement were recorded at 500 cycle-intervals. Pre- and postcyclic loading radiographs were analyzed. An axial load to failure test followed and construct stiffness and failure strength recorded. Biomechanical data were analyzed using a two-way analysis of variance (P < 0.05). Failure modes were descriptively interpreted.
RESULTS: Cyclic testing data revealed no difference between constructs at any interval. Within all construct groups, displacement that occurred did so within the first 500 cycles of testing. Pre- and postcyclic loading radiographic analysis showed no differences in construct deformation. Load to failure testing revealed no differences between groups, whereas volar constructs approached significance (P = 0.08) for increased failure strength. Dorsal constructs failed primarily by fragment subsidence and fragmentation, whereas volar constructs failed by plate bending.
CONCLUSIONS: No difference in all measured biomechanical parameters supports equivalence between constructs and surgeon discretion in determining operative method. Minimal fragment displacement and construct deformation during physiological testing support previous data that early postoperative motion can be recommended. Fragment displacement that occurs does so in the early periods of motion.