Influence of Polymer Side Chain Size and Backbone Length on the Self-Assembly of Supramolecular Polymer Bottlebrushes.

Hydrogen bonds are a versatile tool for creating fibrous, bottlebrush-like assemblies of polymeric building blocks. However, a delicate balance of forces exists between the steric repulsion of the polymer chains and these directed supramolecular forces. In this work we have systematically investigated the influence of structural parameters of the attached polymers on the assembly behaviour of benzene trisurea (BTU) and benzene tris(phenylalanine) (BTP) conjugates in water. Polymers with increasing main chain lengths and different side chain sizes were prepared by reversible addition-fragmentation chain-transfer (RAFT) polymerization of hydroxyethyl acrylate (HEA), tri(ethylene glycol) methyl ether acrylate (TEGA) and oligo(ethylene glycol) methyl ether acrylate (OEGA). The resulting structures were analyzed using small angle X-ray scattering (SAXS) and transmission electron microscopy (TEM). Both BTU and BTP formed fibres with PHEA attached, but a transition to spherical morphologies was observed at degrees of polymerisation (DP) of 70 and above. Overall, the main chain length appeared to be a dominating factor in inducing morphology transitions. Increasing the side chain size generally had a similar effect but mainly impeded any aggregation as is the case of POEGA. Interestingly, BTP conjugates still formed fibres, suggesting that the stronger intermolecular interactions can compensate partially for the steric repulsion.