Oxidation of Selected Phenothiazine Drugs During Sample Preparation: Effects of Varying Extraction Conditions on the Extent of Oxidation.
Аннотация
Characterization of degradation products formed from selected phenothiazine drugs during standard solid-phase extraction (SPE) approaches is described. An analytical method for promethazine (PMZ), chlorpromazine (CPZ) and their respective N-desmethyl and sulfoxide metabolites in biological samples (bone tissue extract and blood) by ultra performance liquid chromatography-photodiode array detection, using mixed-mode SPE for basic drugs was developed. When ethyl acetate:isopropanol:ammonium hydroxide (80:17:3) was used as the elution solvent during method development, extraneous peaks were observed that were absent in the negative controls. Analysis of extracts of PMZ and CPZ individually showed extraneous peaks, including peaks with retention time and UV spectra suggesting the formation of the sulfoxide metabolites, amongst others. Analytes were then extracted individually and analyzed by ultra performance liquid chromatography-quadrupole time-of-flight mass spectrometry. The results confirmed the oxidation of PMZ to its sulfoxide and N-oxide metabolites and oxidation of CPZ to its sulfoxide metabolite. Oxidation was also observed in analysis of whole blood, and thus was not specific to bone tissue extract. To determine if extraction with minimal oxidation was possible, extractions using SPE with a different elution solvent system (dichloromethane:isopropanol:ammonium hydroxide) and filtration/pass through extraction (FPTE) with and without evaporation were evaluated. The results demonstrated that the sample preparation method highly influenced the extent of oxidation. FPTE without an evaporation step was the only method that did not measurably induce analyte oxidation.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.