Isometric torque about the knee joint generated by microstimulation of the cat L6 spinal cord.
Аннотация
Isometric torque was generated about the knee joint by microstimulation of the cat L6 spinal cord using a single microelectrode. The torque responses varied with microstimulation location. Appreciable extension torque was generated by microstimulation in ventrolateral locations of the L6 spinal cord. Stimulation parameters (intensity, frequency and pulse-width) also influenced the extension torque. Specific stimulation parameters (100 microA intensity, 40 Hz frequency and 0.20 ms pulse-width) appear best suited for mapping the spinal cord based on knee joint torque responses. Low levels of cocontraction of the extensor and flexor could be achieved when extension torque was produced, but also varied with the stimulation locations. There are locations in the L6 ventral horn where microstimulation could evoke sustained extension for at least 4 min with only a slight change in torque. This study suggests the possibility of restoring lower limb function in patients with spinal cord injury above the lumbar level.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.