Bicortical screw fixation of distal fibula fractures with a lateral plate: an anatomic and biomechanical study of a new technique.

One of the potential drawbacks of lateral plating of distal fibula fractures is less than satisfactory fixation of unicortical screws commonly placed in the distal fragment to avoid implant penetration of the ankle joint. This study examines the anatomy of the distal fibula, proposes new techniques for bicortical screw fixation and radiographic evaluation of screw placement, and compares pullout strength of unicortical versus bicortical screws in this area. Sixteen pairs of human cadaver feet were used in this study. It was found that a large percentage of the surface area of the distal fibula is nonarticular and that the distal fibula could be divided into 3 zones with distinct anatomic features. Zone I is defined as the distal most 1.5 cm of the fibula, zone II is the next 1 cm of fibula proximal to zone I, and zone III is defined as the fibula above the ankle joint, starting at just over 2.5 cm proximal to the tip of the fibula. We determined a safe corridor for bicortical screw placement by means of a lateral plate in each zone. An improved radiographic view is described for confirmation of extraarticular screw placement. Screw pullout testing was performed on 8 pairs of fresh-frozen human cadaver fibulas. In both zone I and zone II, the bicortical screw fixation was significantly stronger than the unicortical screw fixation. In zone I, the average pullout strength for the bicortical screw fixation was 2.3 times higher than the unicortical screw fixation. In zone II, the average pullout strength for the bicortical screw fixation was 3.3 times higher than the unicortical screw fixation. This study shows that not only is bicortical screw placement in the distal fibula technically feasible, but it is also biomechanically stronger than unicortical placement in this area.