MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1007/bf02072532

Медицинская библиотека · Journal of assisted reproduction and genetics · 1996

Allele dropout in sequential PCR and FISH analysis of single cells (cell recycling).

Rechitsky S, Freidine M, Verlinsky Y, Strom C M

СтатьяПеревод в очереди

Аннотация

PURPOSE: Our purpose was to investigate the feasability of using sequential PCR and FISH analysis of single cells for preimplantation diagnosis.

METHODS

Protocols for sequential PCR and FISH analysis of a single fibroblast (cell recycling) were optimized for six loci and the rates of allele specific dropout (ADO) were determined.

RESULTS

Conditions that allow reliable genotyping of single cells in lysis buffer were not optimal for amplifying fibroblasts fixed to coverslips. After optimizing conditions, we observed a success rate of 85% for both analyses in sequential PCR-FISH experiments in single cells for the four loci studied. The individual success rates for each technique revealed a slightly higher rate for FISH (91-95%) than for PCR (85-87%) for single cells on coverslips. The presence of two hybridization signals in FISH experiments demonstrated that the failure to amplify both alleles from heterozygous cells on coverslips was due to true ADO, and not the loss of chromosomal material. The ADO rate observed on coverslips varied between 10 and 14%, which is significantly higher than that observed in solution, even after meticulous optimization.

CONCLUSIONS

Sequential PCR and FISH analysis of single cells remains an attractive possibility. However, until the problem of the increased rate of ADO is resolved, cell recycling should be applied to clinical preimplantation genetic analysis.

Для цитирования: Rechitsky S, Freidine M, Verlinsky Y, Strom C M. Allele dropout in sequential PCR and FISH analysis of single cells (cell recycling).. Journal of assisted reproduction and genetics. 1996. DOI: 10.1007/bf02072532.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.