Effects of combined modification of sulfonation, oxygen plasma and silane on the bond strength of PEEK to resin.

OBJECTIVE

This study aimed to evaluate the combined effects of sulfonation, non-thermal oxygen plasma and silane on the shear bond strength (SBS) of PEEK to resin materials.

MATERIALS AND

METHODS

Two hundred and eighty specimens were randomly divided into four groups: (A) untreated; (B) sulfonation for 60 s; (C) oxygen plasma for 20 min; (D) sulfonation for 60 s and oxygen plasma for 20 min. According to the instructions, 120 samples (N = 30) were coated with silane, adhesive, and resin composites. Each group of bonding specimens was divided into two subgroups (n = 15) to measure immediate and post-aging SBS. The surface morphology and the interface between the samples and adhesive were analyzed through SEM. Physicochemical characteristics of the surface and mechanical properties were determined through XPS, FTIR, light interferometry, contact angle measurement, and three-point bending tests.

RESULTS

Sulfonation produced a porous layer of approximately 20 µm thickness on the surface, and the oxygen plasma increased the O/C ratio and oxygen-containing groups of the sample surface. After coating with silane, the SBS values of sulfonated PEEK and plasma-treated PEEK increased (9.96 and 10.72 MPa, respectively), and dual-modified PEEK exhibited the highest SBS value (20.99 MPa), which was significantly higher than that of blank group (p > 0.01). After 10,000 thermal cycles, the dual-modified PEEK still displayed a favorable SBS (18.68 MPa).

SIGNIFICANCE: Sulfonation strengthened the mechanical interlocking between PEEK and the resin while oxygen plasma established a chemical bonding between silane and PEEK. This dual modification of the surface microstructure and chemical state synergistically improved the bond strength of PEEK to resin and resulted in considerable long-term effects.