MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1039/d0ra02448a

Медицинская библиотека · RSC advances · 2020

Stability studies of ZnO and AlN thin film acoustic wave devices in acid and alkali harsh environments.

Xiong Shuo, Liu Xudong, Zhou Jian, Liu Yi, Shen Yiping, Yin Xiaobo, Wu Jianhui, Tao Ran, Fu Yongqing, Duan Huigao

СтатьяПеревод в очереди

Аннотация

Surface acoustic wave (SAW) devices based on piezoelectric thin-films such as ZnO and AlN are widely used in sensing, microfluidics and lab-on-a-chip applications. However, for many of these applications, the SAW devices will inevitably be used in acid or alkali harsh environments, which may cause their early failures. In this work, we investigated the behavior and degradation mechanisms of thin film based SAW devices in acid and alkali harsh environments. Results show that under the acid and alkali attacks, chemical reaction and corrosion of ZnO devices are very fast (usually within 45 s). During the corrosion, the crystalline orientation of the ZnO film is not changed, but its grain defects are significantly increased and the grain sizes are decreased. The velocity of ZnO-based SAW devices is decreased due to the formation of porous structures induced by the chemical reactions. Whereas an AlN thin-film based SAW device does not perform well in acid-alkali conditions, it might be able to maintain a normal performance without obvious degradation for more than ten hours in acid or alkali solutions. This work could provide guidance for the applications of both ZnO or AlN-based SAW devices in acid/alkali harsh environments.

Для цитирования: Xiong Shuo, Liu Xudong, Zhou Jian, Liu Yi, Shen Yiping, Yin Xiaobo, Wu Jianhui, Tao Ran, Fu Yongqing, Duan Huigao. Stability studies of ZnO and AlN thin film acoustic wave devices in acid and alkali harsh environments.. RSC advances. 2020. DOI: 10.1039/d0ra02448a.
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.