DOI 10.1016/j.aanat.2021.151696
Time is bone - Quantitative comparison of decalcification solvents in human femur samples using dual-X-ray-absorptiometry and computed tomography.
Аннотация
INTRODUCTION
Bone decalcification is a necessary preprocessing step in histological and anatomical studies. Several solutions for decalcification with different claimed times for full decalcification are commercially available. Current literature lacks direct, quantitative measurement of calcium hydrocyapatite degradation during decalcification to compare different solutions. Therefore, the aim of this study was to test the performance of three different decalcification solutions in human bone by direct measurement of calcium hydroxyapatite using dual-X-ray-absorptiometry (DEXA) and volumetric computed tomography (CT).
METHODS
Four femur slices were acquired from the proximal femur of a 76-year-old body donor. The slices were submerged in formaldehyde (control), EDTA, Osteosoft (Merck, Darmstadt, Germany) and "Rapid Bone Decalcifier" (RBD) (American MasterTech Scientific, Lodi, USA). Consecutive DEXA and CT scans were performed at 2 h, 4 h, 8 h, 11 h, 20 h, 44 h and 77 h after solutions were added. Besides the calcium hydroxyapatite concentration, the bone volume was measured each time.
RESULTS
Fastest decline in volume was seen in the RBD probe. Further, RBD was the only solution, being able to fully decalcify the bone slice after 77 h. Although a steady decline in volume and hydroxyapatite concentration was seen for EDTA and Osteosoft as well, both were not able to decalcify the slices.
CONCLUSION
Overall, the purely qualititve acquired literature data on bone decalcifiers was verified by our quantitative data for human, cortical-rich bones. Hydrochloric-acid based solutions seem to be preferable in order to rapidly dissolve the calcium hydroxyapatite.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.