MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1007/s10928-007-9066-0

Медицинская библиотека · Journal of pharmacokinetics and pharmacodynamics · 2007

Implementation of a transit compartment model for describing drug absorption in pharmacokinetic studies.

Savic Radojka M, Jonker Daniël M, Kerbusch Thomas, Karlsson Mats O

СтатьяПеревод в очереди

Аннотация

PURPOSE: To compare the performance of the standard lag time model (LAG model) with the performance of an analytical solution of the transit compartment model (TRANSIT model) in the evaluation of four pharmacokinetic studies with four different compounds.

METHODS

The population pharmacokinetic analyses were performed using NONMEM on concentration-time data of glibenclamide, furosemide, amiloride, and moxonidine. In the TRANSIT model, the optimal number of transit compartments was estimated from the data. This was based on an analytical solution for the change in drug concentration arising from a series of transit compartments with the same first-order transfer rate between each compartment. Goodness-of-fit was assessed by the decrease in objective function value (OFV) and by inspection of diagnostic graphs.

RESULTS

With the TRANSIT model, the OFV was significantly lower and the goodness-of-fit was markedly improved in the absorption phase compared with the LAG model for all drugs. The parameter estimates related to the absorption differed between the two models while the estimates of the pharmacokinetic disposition parameters were similar.

CONCLUSION

Based on these results, the TRANSIT model is an attractive alternative for modeling drug absorption delay, especially when a LAG model poorly describes the drug absorption phase or is numerically unstable.

Для цитирования: Savic Radojka M, Jonker Daniël M, Kerbusch Thomas, Karlsson Mats O. Implementation of a transit compartment model for describing drug absorption in pharmacokinetic studies.. Journal of pharmacokinetics and pharmacodynamics. 2007. DOI: 10.1007/s10928-007-9066-0.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.