Release of corrosion products from amalgam in phosphate containing solutions.

The effect of phosphate concentration on corrosion was compared for two types of amalgam: a conventional alloy (ANA 68) and a high-Cu admixed alloy (Dispersalloy). The test specimens were stored for 4 months in electrolytes containing 85 mM NaCl and 85 mM NaCl with 2.5, 10, or 100 mM phosphate buffer respectively. The solutions were renewed each month and analyzed for Cu, Zn, Sn, Hg, and Ag in an atomic absorption spectrophotometer. The surfaces and cross-sections of the specimens were studied in a scanning electron microscope (SEM) with an energy dispersive detector (EDAX). The corrosion products, mainly Sn-compounds, at the surface of the amalgams were less in the solutions containing high concentrations of phosphate. In cross-section subsurface corrosion of the high-Cu amalgam was observed especially in specimens immersed in the NaCl solution without phosphate. The conventional amalgam showed surface corrosion only. The decrease in release of elements with time from the conventional amalgam in all the experimental solutions might indicate passivation. For the high-Cu amalgam the release of elements increased with time, except for Cu and Sn in the solution with 100 mM phosphate, indicating that phosphate inhibits corrosion of the Cu-Sn-phases. Release of corrosion products from the high-Cu amalgam was more dependent on the presence of phosphate than the conventional amalgam.