DOI 10.1016/0735-1097(93)90370-g
Mitral valve area calculations immediately after percutaneous balloon mitral valvuloplasty: effect of the atrial septal defect.
Аннотация
OBJECTIVES
The aim of this study was to assess the effect of the atrial septal defect on mitral valve area calculations after balloon mitral valvuloplasty.
BACKGROUND
There is poor correlation between the hemodynamic-derived and Doppler mitral valve area immediately after mitral valvuloplasty. The reasons for this are unclear.
METHODS
Twenty-five patients with severe mitral stenosis were studied. After balloon mitral valvuloplasty, serial mitral valve area calculations were performed with 1) the mitral dilating catheter across the atrial septum, 2) the 7F catheter across the atrial septum, and 3) with the atrial puncture site occluded with the balloon catheter.
RESULTS
The mitral valve area determined by the Gorlin formula with balloon occlusion of the atrial septum was smaller than the mitral valve area determined without balloon occlusion (mean +/- SD 1.8 +/- 0.43 vs. 2.24 +/- 0.67 cm2, p < 0.005 for the mitral dilating catheter across the atrial septum and 1.8 +/- 0.43 vs. 2.19 +/- 0.52, p < 0.05 for the 7F catheter across the atrial septum). The mean of the differences between the mitral valve area derived by the Gorlin formula and by the Doppler pressure half-time method was smaller with the atrial septum occluded than when the dilating catheter or the 7F catheter was across the atrial septum (0.12 +/- 0.26 vs. 0.56 +/- 0.48 cm2 [p < 0.005] and 0.12 +/- 0.26 vs. 0.48 +/- 0.55 cm2 [p < 0.05]). Left to right shunting was detected less frequently by oximetry (60%), than by shunt ratios calculated by using the cardiac output measurements with and without balloon occlusion of the atrial septum (84%).
CONCLUSIONS
The presence of left to right shunts after mitral valvuloplasty may account for some of the discrepancies between mitral valve area found at cardiac catheterization and that by the Doppler pressure half-time method; thus, the latter method may be reliably used to follow up patients in the long term.
Предметные рубрики MeSH
Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Ошибки и ограничения
История · было → стало
Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.
Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.