MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1097/00005537-200406000-00019

Медицинская библиотека · The Laryngoscope · 2004

An alternative technique for nasal biopsy.

Thornton M A, Walshe P, Costello R W, McConn-Walsh R, Walsh M A

СтатьяПеревод в очереди

Аннотация

OBJECTIVES/HYPOTHESIS: The objective was to investigate the effectiveness of co-phenylcaine as a topical anesthetic agent for nasal mucosal biopsy.

STUDY

DESIGN

A prospective study.

METHODS

Nasal mucosal biopsy specimens were taken from a site just anterior to the inferior turbinate following topical anesthesia with co-phenylcaine. All volunteers graded pain according to standard visual analogue scale (0-10) (VAS) scoring, and all were followed up after 24 hours for any epistaxis.

RESULTS

Ninety nasal biopsy specimens were removed from 41 patients in all. Eight-two percent did not report any discomfort following this procedure (VAS score, 0). Ten patients reported mild discomfort (VAS scores ranging between, 1 and 3) and only six reported pain (VAS scores ranging from 5 to 7). However, five of these patients agreed to further biopsy and documented no discomfort during the repeat procedure. Only one patient required immediate intervention for hemorrhage after the procedure. In cases in which bleeding occurred (seven patients) it was documented within the first 6 hours, was minimal in content, and was controlled with local pressure. No systemic side effects were experienced.

CONCLUSION

Co-phenylcaine is a suitable topical anesthetic agent for nasal mucosal biopsy. Removal of nasal tissue from a site anterior to the inferior turbinate can be performed under direct vision and provides sufficient tissue for histological assessment.

Для цитирования: Thornton M A, Walshe P, Costello R W, McConn-Walsh R, Walsh M A. An alternative technique for nasal biopsy.. The Laryngoscope. 2004. DOI: 10.1097/00005537-200406000-00019.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.