MedElevator Войти в исследования
← Поиск публикаций

DOI 10.1177/1076029611430955

Медицинская библиотека · Clinical and applied thrombosis/hemostasis : official journal of the International Academy of Clinical and Applied Thrombosis/Hemostasis · 2012

The effects of aminoglycoside antibiotics on platelet aggregation and blood coagulation.

Chen Guoqiang, Fei Xianming, Ling Jie

Клиническое исследованиеСтатьяПеревод в очереди

Аннотация

OBJECTIVE

To investigate the effects of different aminoglycoside antibiotics on platelet aggregation and blood coagulation, as well as the underlying mechanisms.

METHOD: Blood samples were collected and prepared as platelet-rich plasma and platelet-poor plasma samples. Then assigned into different groups for the following antibiotics treatments: gentamicin, streptomycin, etimicin, amikacin, and kanamycin, as group 0 mg/L, group 30 mg/L, group 91mg/L, and group 910 mg/L for each drugs. The maximum platelet aggregation rate induced by adenosine diphosphate, expression levels of CD62p and FIB-R, prothrombin time, activated partial thromboplastin time, thrombin time, and fibrinogen were measured. The sodium citrate and sodium heparin were used in whole blood tests for the whole blood coagulation time as well as the Ca(2+) in blood plasma.

RESULTS

Amikacin and gentamicin could inhibit the aggregation of platelets, which contributed to the whole blood clotting disorder.

CONCLUSION

Amikacin and gentamicin might inhibit the platelet aggregation by blocking the activation and release of FIB-R or probably the inhibition of endogenous clotting factor as well. This effect was not dependent on calcium ions.

Для цитирования: Chen Guoqiang, Fei Xianming, Ling Jie. The effects of aminoglycoside antibiotics on platelet aggregation and blood coagulation.. Clinical and applied thrombosis/hemostasis : official journal of the International Academy of Clinical and Applied Thrombosis/Hemostasis. 2012. DOI: 10.1177/1076029611430955.

Предметные рубрики MeSH

Подготовка и перевод публикации
Обработка статьи · этапы, ошибки и управление
Загрузка состояния…

История · было → стало

Состояние обновляется каждые 5 секунд, пока блок открыт. Процент показывается только там, где известен объём работы. Пауза останавливает продолжение этапа; текущий запрос к источнику может завершиться.

Тип публикации указан по данным источника. Уровень доказательности автоматически не присваивается.