Influence of axle-wheel interface on ultrasonic testing of fatigue cracks in wheelset.

For the ultrasonic testing at the wheel seat of railway axles, quantitative investigation of the reflection and transmission phenomena at the axle-wheel interface is important. This paper describes the influence of the axle-wheel interface on the ultrasonic testing of a fatigue crack in a wheelset by applying the spring interface model. The normal and tangential stiffnesses were identified experimentally for an as-manufactured wheelset at the normal incidence, and the reflection coefficient for the shear-wave oblique incidence was calculated. A parametric study was performed to clarify the influence of these interfacial stiffnesses on the incident-angle dependence of the reflection coefficient. The calculated reflection coefficient at the incident angle of 45° qualitatively explained the relative echo-height decrease due to the presence of a wheel observed experimentally for a wheelset in fatigue loading by rotating bending. The quantitative difference between the experimental and calculated results was considered to be due to the reduction of the effective interference of shrink fit by the wear at the axle-wheel interface during the fatigue loading as well as by the applied bending moment. For the estimated relative echo-height decrease to agree with the experimental results, the interfacial stiffnesses were found to be smaller than the values identified for the as-manufactured wheelset by a factor of 0.5-0.7.