Geopolymer-Based Solution for the Stabilization of Iron Ore Tailings Byproduct.

This study investigated the development of a perlite waste-based geopolymer for stabilizing iron ore tailings byproduct (IOTB) for geotechnical applications. Mixtures containing 70/30 and 80/20 proportions of byproduct and geopolymer were produced using perlite waste as the precursor and NaOH as the alkaline activator through the one-part method. Raw and geopolymer-stabilized IOTB, air-cured for 7, 14, and 28 days, were evaluated by ICP-OES, XRF, pH, geotechnical characterization, compaction, permeability, SEM, and consolidated drained triaxial tests under confining stresses ranging from 250 to 2000 kPa. The selected mixture presented a maximum dry density of 1.8 g/cm3 and optimum moisture content of approximately 14%. XRD results indicated sodium aluminosilicate phases associated with geopolymerization, with mechanical characteristics comparable to feldspar-type structures, while the pH increased from 6.5 to 12.5. Triaxial tests indicated that elastoplastic behavior persisted regardless of the geopolymer addition; however, SEM images confirmed matrix-particle bonding at grain contacts without significant pore filling. The cohesive intercept increased from 0 kPa in the IOTB to 89.1 kPa and 179.2 kPa after 14 and 28 days of curing, respectively, while the friction angle showed a slight increase of up to 7.7%. Deviatoric stress at failure and energy absorption capacity also increased with curing time. Hydraulically, the permeability coefficient remained within the same order of magnitude (10-4 cm/s), varying from raw IOTB of 2.73 × 10-4 cm/s to 3.28 × 10-4 cm/s after 28 days. These results demonstrated that geopolymer stabilization enhanced mechanical performance without compromising drainage capacity, representing a technically viable and socio-environmentally sustainable solution.